Ebashi Audio releases 6 new modules like CMOS 7555 CORE VCO/259 Timbre /Dual Wavefolder and more
Ebashi Audio releases 6 new modules on the market
It features Linear AC and Exponential FM inputs with attenuators, one Hard Sync input and a 1V / Octave tacking input, output and offset switch.
Connecting a signal to the EXP FM input will change the pitch of the oscillator.
The H-Sync and FM functions produce a full sound, and it octave tracks very well.
This VCO features four waveforms: Sine, Triangle, Ramp and Pulse wave.
There are trimpots for 1Volt / Octave tuning, High Frequency tracking, and Ramp wave connection. There are two trimpots for the sine wave: one for roundness and one for symmetry. The roundness trimmer also adjusts the amplitude of the sine wave a little.
Parameters are already set. If you would like to adjust these you can do it by ear or using an oscilloscope.
This 7555 VCO also features a 3-way switch providing 3 frequency ranges: MID, VCO and LFO.
The back of the module allows you to ‘pre patch’ various functions.
The Ebashi 259 Timbre module is a dual wavefolder inspired by the famous Timbre section of the Buchla 259 oscillator as implemented in the Easel.
There are four CV inputs, the first and fourth can be controlled with an attenuverter.
Two IN attenuators control the overall wavefold amount of each wavefolder.
Two inputs allow two oscillators to drive the Dual 295 Buchla Timbre simultaneously.
A switch enables the rich timbres of both wavefolders to be shaped in series or parallel.
The back of the module allows you to ‘pre patch’ various functions, including CV 1 and 4 as well as both inputs and outputs. There are also two trimpots for gain adjustment.
Part of the forthcoming Ebashi EXP range.
The Dual Wavefolder features 4 CV inputs, a Mix Out, and a Series and Parallel switch.
The first and fourth CV inputs can be controlled with an attenuverter.
The shape and range of each wavefolder can be adjusted with the attenuators.
Two inputs allow two oscillators to drive the both wavefolders simultaneously.
A switch enables the rich timbres of both wavefolders to be shaped in series or parallel.
The back of the module allows you to ‘pre patch’ various functions, including CV 1 and 4 as well as both inputs and outputs. There are also two trimpots for gain adjustment and two trimpots for symmetry adjustment.
Can be split in 2 separate, 2 in parallel and 2 in series.
The back of the module allows you to ‘pre patch’ certain functions.
Prices and more info here on official site Ebashi audio!